3 in 1 new flush trim bits with Delrin Triangular bearings are Our best partner for laminate trimming. In fact, it solves three of the most common problems that occur when flush trimming:
1) The anti-stick properties of the Delrin bearing greatly reduces the likelihood of freezing of the bearing from glue.
2) The extended guide surface of the new Delrin bearing will perfectly match the work surface without scratching like a steel bearing would. The Delrin bearing also guarantees maximum stability.
3) The shear angle cutting edge reduces the need for filing. 3-in-1 bits are ideal on plastic laminates as well as aluminium laminates.
Perfect Trimming with Conical Edges
Thanks to the innovative conical edges of this bit, We will always get perfect cuts even after re-sharpening. In fact, the most common problem We have with standard flush trim bits is the undersized diameter after re-sharpening which leaves a mark on the material; with the new CMT construction Us could re-sharpen up to six times without any problem. Just remember to adjust Our bit up or down as per the illustration.
WARNING: Proposition 65 Warning for California Residents View Details
