Creates a harder and tougher cutting edge allows for a prolonged cutting edge life and helps to prevent the build-up of material in the flutes while cutting
Have the tendency to run/spin much faster than an uncoated tool
Optimized flute geometry and low Total Indicated Runout (TIR) guarantees clean cuts, essentially eliminates sanding and reduces chatter (where the machine or work piece vibrates) under high chip loads (when used with low TIR spindles)
High flute volume supports high feed rates and chip loads
High aspect ratio for single pass deep-reach cutting
Flute geometry optimized for cutting sign foam, sign board, hardwoods, thermoplastics and phenolic composites
Application
For Extra-Fine Carving and Lettering Details and Used for Wood, Plastic, Aluminum and Solid Surface Materials
Material
Solid Carbide
Type
Router Bit
Angle (a°)
45 Deg
Diameter (D)
1/4"
Cutting Height (B)
0.272"
Shank Diameter (d)
1/4"
Overall Length (L)
2"
Tip Width (t)
0.025"
Coating
ZrN
Maximum Speed (RPM)
28,000 RPM
Soft Wood / Hard Wood / Soft Plastic / Hard Plastic / Aluminum / Solid Surface (Feed Rate IPM* / Chip Load Per Tooth IPR**)
