With Invectra router bits, kitchen fabricators, remodelers and construction workers can perform any kind of cut and trim job in aluminum laminates. Designed and tested for trimming all decorative aluminum laminates manufactured by Formica (except Formica #2178), Advanced Technology Inc. (ATI), DecoMetal and many others.
Engineered from an Amana Tool exclusive carbide grade designed specifically for cutting both aluminum laminates and wood-based substrate materials. Each bit is fitted with a steel bearing guide that enables users to trim laminate materials flush to the substrate, allowing us to perform any metal trim job to perfection
Not for use on stainless steel.
WARNING: Proposition 65 Warning for California Residents View Details
Creates a harder and tougher cutting edge allows for a prolonged cutting edge life and helps to prevent the build-up of material in the flutes while cutting
Have the tendency to run/spin much faster than an uncoated tool
Optimized flute geometry and low Total Indicated Runout (TIR) guarantees clean cuts, essentially eliminates sanding and reduces chatter (where the machine or work piece vibrates) under high chip loads (when used with low TIR spindles)
High flute volume supports high feed rates and chip loads
High aspect ratio for single pass deep-reach cutting
Flute geometry optimized for cutting sign foam, sign board, hardwoods, thermoplastics and phenolic composites
