The connection between your parallel guides and your guide rail is critical. It needs to feel like an extension of your guide rail—while still being fast to add, remove, and reposition between cuts. The new Drop-Loc Connector delivers both.
Unlike the old Slide-On TPG Adapter (rigid but slow to install) or the Drop-On TPG Adapter (fast but not mechanically secure if you lifted the rail), the Drop-Loc Connector combines speed, security, and convenience in one design.
What makes the Drop-Loc Connector truly different is the drop-in freedom it gives you. Instead of sliding it in from the end of the rail or carefully working around other accessories, you can press a button on the connector and insert it at any point along the track. That means setup takes seconds and you stay in flow, even if your rail already has hose deflectors, guide rail connectors, or other attachments occupying the T-slot. It’s a small change that can add up to major time savings, especially when you’re moving quickly between cuts.
The little connector may seem easy to overlook, but it’s what unlocks speed and accuracy. With Drop-Loc Connectors, you’ll spend less time setting up and more time cutting.
WARNING: Proposition 65 Warning for California Residents View Details
Two Come Standard: A pair of Drop-Loc Connectors is included in every Parallel Guide System Gen 2 kit (order here for extras)
Tool-Free Connection: A press of a button is all it takes to insert the Drop-Loc Connector into your guide rail T-track
Drop-In Anywhere: Insert at any point along your guide rail T-track. No need to slide in from the ends, and no need to remove accessories like hose deflectors
Rigid & Secure: Once installed, the connector is mechanically captured inside the guide rail T-track. You can lift and move the guide rail with the Parallel Guides attached, with no risk of them falling out
Slide to Reposition: Press the button to slide the connector along the rail, or tilt to remove instantly
Universal Fit: Works with Festool, Makita, Milwaukee, Kreg, Ridgid, Powertec, and Wen guide rails
Built for Gen 2 Only: These connectors are not compatible with the original Parallel Guide System (Gen 1)